Can now use the buttons to change programs, change active LED zones, change LED brightness and enter and exit programming mode. Exiting programming mode will save settings. Holding MODE upon boot will load defaults (though not overwrite them in EEPROM).
Also added basic power management. If the badge is still for 15min, LEDs will go out. When LEDs are blank due to brightness off setting or timeout, they are turned off to save power. Moving badge, entering programming mode, changing the program, or changing brightness will enable the LEDs.
Flash pages are only erased as needed during the flash routine, which makes flashing faster as well as making the transfer consistent.
Later datasheets have the flash clock set to 2MHz. I've set it to 2MHz here. I may undo this change later depending on how slow loading a 14K firmware feels.
Was able to save enough space to reduce bootloader size from almost 2.5K to 2K exactly. Adjusted flash offsets to start from 0x800.
GPIO values are now mostly reset to power-on defaults.
Fixed some formatting. Removed dead code.
Patches to allow programming and debugging using a JLINK within the STM32CubeIDE environment.
Also firmware to turn STM32F103 into JLink-OB. However you will need to click on "No" every time you launch.
From memory, these are the pins used:
PA5 SWDCK
PA4 SWDIO
PA2 !RST (unneeded)
You may need to attach a 100ohm resistor from PA7 to PA4 for this to work.
Took a publicly available XMODEM bootloader and made it work on HK32F.
Known issues:
- Erase is super slow on this MCU. The upload routine erases all flash before loading, which means the first packet seems to hang. This also erases possibly persistent data stored in unused pages on flash.
true
true