sc7-testo-firmware/include/probe.h

/*
 * probe.c: helping you probe things
 *
 * file creation: 20231021 1717
 */

#ifndef _INC_PROBE_H
#define _INC_PROBE_H


#include <stdint.h>


void probe_mode_switch(uint8_t mode);

void probe_measure();

void probe_set_thresh(uint8_t set);
uint8_t probe_get_thresh();


#endif /* _INC_PROBE_H */
Continuity and diode mode initial implementation Reads continuity at a fixed ~100ohm or lower, and diodes with intelligent detection of LEDs vs normal diodes. Some values may need to be changed still. 2023-10-21 19:45:15 -07:00			`/*`
			`* probe.c: helping you probe things`
			`*`
			`* file creation: 20231021 1717`
			`*/`

			`#ifndef _INC_PROBE_H`
			`#define _INC_PROBE_H`


			`#include <stdint.h>`



			`void probe_mode_switch(uint8_t mode);`

			`void probe_measure();`

Fix diode check limits, allow for two-mode continuity limit D1 has changed to a 5V1 zener and is loading the circuit a little bit. Adjusted voltage based on tested value on prototype. This value may differ on production units so expect this to possibly change. 2023-10-31 19:50:30 -07:00			`void probe_set_thresh(uint8_t set);`
			`uint8_t probe_get_thresh();`

Continuity and diode mode initial implementation Reads continuity at a fixed ~100ohm or lower, and diodes with intelligent detection of LEDs vs normal diodes. Some values may need to be changed still. 2023-10-21 19:45:15 -07:00

			`#endif /* _INC_PROBE_H */`