{
    "type": "filament",
    "name": "Polymaker PETG @Snapmaker U1",
    "from": "system",
    "instantiation": "true",
    "cool_plate_temp": [
        "60"
    ],
    "eng_plate_temp": [
        "0"
    ],
    "hot_plate_temp": [
        "80"
    ],
    "textured_plate_temp": [
        "80"
    ],
    "cool_plate_temp_initial_layer": [
        "60"
    ],
    "eng_plate_temp_initial_layer": [
        "0"
    ],
    "hot_plate_temp_initial_layer": [
        "80"
    ],
    "textured_plate_temp_initial_layer": [
        "80"
    ],
    "overhang_fan_threshold": [
        "95%"
    ],
    "overhang_fan_speed": [
        "100"
    ],
    "slow_down_for_layer_cooling": [
        "1"
    ],
    "close_fan_the_first_x_layers": [
        "3"
    ],
    "filament_end_gcode": [
        "; filament end gcode \n"
    ],
    "filament_flow_ratio": [
        "0.96"
    ],
    "filament_cost": [
        "0"
    ],
    "filament_diameter": [
        "1.75"
    ],
    "filament_max_volumetric_speed": [
        "15"
    ],
    "filament_minimal_purge_on_wipe_tower": [
        "15"
    ],
    "filament_vendor": [
        "Polymaker"
    ],
    "bed_type": [
        "Cool Plate"
    ],
    "nozzle_temperature_initial_layer": [
        "260"
    ],
    "full_fan_speed_layer": [
        "0"
    ],
    "fan_max_speed": [
        "10"
    ],
    "fan_min_speed": [
        "50"
    ],
    "slow_down_min_speed": [
        "10"
    ],
    "slow_down_layer_time": [
        "6"
    ],
    "filament_start_gcode": [
        "; Filament gcode\n"
    ],
    "nozzle_temperature": [
        "260"
    ],
    "temperature_vitrification": [
        "71"
    ],
    "filament_id": "PMPE01",
    "nozzle_temperature_range_high": [
        "260"
    ],
    "nozzle_temperature_range_low": [
        "240"
    ],
    "supertack_plate_temp": [
        "70"
    ],
    "supertack_plate_temp_initial_layer": [
        "70"
    ],
    "setting_id": "PMPE01_U1",
    "compatible_printers": [
        "Snapmaker U1 (0.4 nozzle)"
    ],
    "inherits": "Polymaker PETG @Base"
}