{
    "type": "filament",
    "name": "Prusa Generic TPU @CORE One",
    "inherits": "fdm_filament_flex",
    "from": "system",
    "setting_id": "GFSA04",
    "filament_id": "Prusa Generic TPU @CORE One",
    "instantiation": "true",
    "chamber_temperature": [
        "30"
    ],
    "close_fan_the_first_x_layers": [
        "3"
    ],
    "compatible_printers": [
        "Prusa CORE One 0.25 nozzle",
        "Prusa CORE One 0.3 nozzle",
        "Prusa CORE One 0.4 nozzle",
        "Prusa CORE One 0.5 nozzle",
        "Prusa CORE One HF 0.4 nozzle",
        "Prusa CORE One HF 0.5 nozzle"
    ],
    "fan_cooling_layer_time": [
        "100"
    ],
    "fan_max_speed": [
        "50"
    ],
    "fan_min_speed": [
        "30"
    ],
    "filament_cost": [
        "82"
    ],
    "filament_density": [
        "1.22"
    ],
    "filament_deretraction_speed": [
        "20"
    ],
    "filament_diameter": [
        "1.75"
    ],
    "filament_end_gcode": [
        "; Filament-specific end gcode"
    ],
    "filament_flow_ratio": [
        "1.08"
    ],
    "filament_max_volumetric_speed": [
        "2.5"
    ],
    "filament_minimal_purge_on_wipe_tower": [
        "15"
    ],
    "filament_notes": [
        ""
    ],
    "filament_retraction_length": [
        "2.5"
    ],
    "filament_retraction_minimum_travel": [
        "2"
    ],
    "filament_retraction_speed": [
        "60"
    ],
    "filament_soluble": [
        "0"
    ],
    "filament_start_gcode": [
        "M900 K0 ; Filament gcode\n\nM142 S36 ; set heatbreak target temp"
    ],
    "filament_type": [
        "FLEX"
    ],
    "filament_vendor": [
        "Generic"
    ],
    "filament_wipe": [
        "0"
    ],
    "filament_z_hop": [
        "0"
    ],
    "hot_plate_temp": [
        "50"
    ],
    "hot_plate_temp_initial_layer": [
        "50"
    ],
    "idle_temperature": [
        "150"
    ],
    "nozzle_temperature": [
        "230"
    ],
    "nozzle_temperature_initial_layer": [
        "230"
    ],
    "overhang_fan_speed": [
        "70"
    ],
    "reduce_fan_stop_start_freq": [
        "1"
    ],
    "slow_down_layer_time": [
        "10"
    ],
    "slow_down_min_speed": [
        "15"
    ]
}