{
    "type": "filament",
    "name": "Artillery PA @Artillery M1 Pro 0.4 nozzle",
    "inherits": "Artillery Generic PLA",
    "from": "system",
    "instantiation": "true",
    "complete_print_exhaust_fan_speed": [
        "0"
    ],
    "during_print_exhaust_fan_speed": [
        "0"
    ],
    "fan_cooling_layer_time": [
        "100"
    ],
    "fan_max_speed": [
        "90"
    ],
    "fan_min_speed": [
        "60"
    ],
    "filament_flow_ratio": [
        "0.99"
    ],
    "filament_max_volumetric_speed": [
        "8"
    ],
    "additional_cooling_fan_speed": [
        "0"
    ],
    "filament_settings_id": [
        "Artillery PA @Artillery M1 Pro 0.4 nozzle"
    ],
    "filament_type": [
        "PA"
    ],
    "nozzle_temperature": [
        "240"
    ],
    "nozzle_temperature_initial_layer": [
        "240"
    ],
    "nozzle_temperature_range_high": [
        "280"
    ],
    "nozzle_temperature_range_low": [
        "240"
    ],
    "slow_down_layer_time": [
        "6"
    ],
    "compatible_printers": [
        "Artillery M1 Pro 0.4 nozzle"
    ],
    "filament_retraction_length": [
        "0.8"
    ],
    "filament_retraction_speed": [
        "30"
    ],
    "filament_start_gcode": [
        ""
    ],
    "filament_vendor": [
        "Artillery"
    ],
    "filament_z_hop": [
        "0.6"
    ],
    "temperature_vitrification": [
        "108"
    ],
    "enable_pressure_advance": [
        "1"
    ],
    "hot_plate_temp": [
        "100"
    ],
    "hot_plate_temp_initial_layer": [
        "100"
    ],
    "slow_down_min_speed": [
        "10"
    ],
    "filament_retract_lift_below": [
        "259"
    ],
    "filament_deretraction_speed": [
        "30"
    ],
    "textured_plate_temp": [
        "100"
    ],
    "textured_plate_temp_initial_layer": [
        "100"
    ],
    "cool_plate_temp": [
        "100"
    ],
    "cool_plate_temp_initial_layer": [
        "100"
    ],
    "chamber_temperature": [
        "50"
    ],
    "close_fan_the_first_x_layers": [
        "3"
    ],
    "overhang_fan_threshold": [
        "0%"
    ],
    "pressure_advance": [
        "0.07"
    ]
}