{
    "type": "filament",
    "name": "Elegoo PC @ECC2",
    "inherits": "Elegoo PC @base",
    "from": "system",
    "setting_id": "EPCECC2",
    "instantiation": "true",
    "pressure_advance": [
        "0.024"
    ],
    "nozzle_temperature": [
        "270"
    ],
    "nozzle_temperature_initial_layer": [
        "270"
    ],
    "nozzle_temperature_range_high": [
        "270"
    ],
    "nozzle_temperature_range_low": [
        "250"
    ],
    "overhang_fan_threshold": [
        "25%"
    ],
    "slow_down_layer_time": [
        "6"
    ],
    "textured_plate_temp": [
        "100"
    ],
    "textured_plate_temp_initial_layer": [
        "100"
    ],
    "fan_cooling_layer_time": [
        "30"
    ],
    "fan_max_speed": [
        "35"
    ],
    "fan_min_speed": [
        "10"
    ],
    "filament_max_volumetric_speed": [
        "16"
    ],
    "filament_start_gcode": [
      "; filament start gcode\n{if  (bed_temperature[current_extruder] >55)||(bed_temperature_initial_layer[current_extruder] >55)}M106 P3 S200\n{elsif(bed_temperature[current_extruder] >50)||(bed_temperature_initial_layer[current_extruder] >50)}M106 P3 S150\n{elsif(bed_temperature[current_extruder] >45)||(bed_temperature_initial_layer[current_extruder] >45)}M106 P3 S50\n{endif}\n\n{if activate_air_filtration[current_extruder] && support_air_filtration}\nM106 P3 S{during_print_exhaust_fan_speed_num[current_extruder]} \n{endif}"
    ],
    "compatible_printers": [
        "Elegoo Centauri Carbon 2 0.4 nozzle",
        "Elegoo Centauri Carbon 2 0.6 nozzle",
        "Elegoo Centauri Carbon 2 0.8 nozzle"
    ]
}